How to deal with the surface of iron gate, please explain it to us!

一、清除焊渣 鐵藝大門的焊接部位較多，必須認真清除每個焊接部位的焊渣。先用板銼或扁鐵敲打除渣，然后用磨光機和砂布打磨焊縫，使其平滑。對飛濺到其他部位的焊渣也要順勢清除干凈。

1、 There are many welding parts in the iron gate to remove welding slag, so the welding slag of each welding part must be removed carefully. First, use a plate file or flat iron to knock off the slag, and then use a polishing machine and abrasive cloth to polish the weld to make it smooth. The welding slag splashed to other parts should also be removed.

二、涂抹原子灰 用原子灰加固化劑(比例50:1)攪拌均勻，涂抹在焊接部位.處理焊縫缺陷。

2、 Apply putty with putty and curing agent (proportion 50:1), mix evenly, smear on the welding position, and deal with weld defects.

三、打磨原子灰 干透后，用磨光機和砂布打磨大門的各個組件，尤其是涂抹原子灰的部位更要磨光。

3、 After the putty is completely dry, use a polishing machine and abrasive cloth to polish all components of the gate, especially the parts coated with putty.
 

四、噴漆 噴漆前，用濕布擦凈大門的各個部位，不能留有灰塵等。道噴防銹漆，漆膜干透后噴第二道黑漆，后噴一道清漆。注意不能有漏噴部位，也不能產生流掛等缺陷。個別細微處可用刷子刷涂補漆。

4、 Before spray painting, wipe all parts of the gate with a wet cloth, and there should be no dust left. After the film is dry, spray the second layer of black paint, and then spray a layer of varnish. Attention should be paid to no leakage or sagging. Some tiny parts can be applied with brush.

通過以上的講解，相信大家對鐵藝大門表面如何處理有了一定的了解，如果想要深入了解，請關注我們的官網：http://www.c6271.cn

Through the above explanation, I believe you have a certain understanding of how to deal with the surface of the iron gate. If you want to know more about it, please pay attention to our official website: http://www.c6271.cn